Τεχνικές ερωτήσεις για ηλεκτρονικά εξαρτήματα θα εξυπηρετούνται μέσω τηλεφώνου Δευτέρα εως Παρασκευή καθώς δεν υπάρχει τεχνικός για δια ζώσης εξυπηρέτηση στο φυσικό κατάστημα. Επίσης τα Σάββατα προσωρινά δεν υπάρχει καθόλου τεχνικός ηλεκτρονικών

Σχετικά με την κάλυψη διαθέσιμης θέσης ηλεκτρονικού μπορείτε να στέλνετε βιογραφικά στο iraklis@cableworks.gr

RJ45 Adapter Module for Arduino - 5-30m
Κωδικός Cableworks: 1140.404

BrandOEM MPNOEM
2.34
χωρίς ΦΠΑ 1.89
Σε Απόθεμα
+
Wishlist
Αποστολές & Επιστροφές
Τρόποι πληρωμής
Γιατί Cableworks;
Γρήγορη και ασφαλής παράδοση

Αποστέλλουμε παραγγελίες σε όλη την Ελλάδα με ΕΛΤΑ Courier και ACS

Presales και Aftersales

Για να σας λύνονται όλες οι τεχνικές απορίες

Επιστροφές εντός 14 ημερών

Αρκεί το προϊόν να μην έχει ανοιχτεί και να μην έχουν προκληθεί φθορές στην συσκευασία του

CABLEWORKS

Αναλυτική Παρουσίαση

Description

RJ45 interface adapter module is an interface to turn the ordinary into the use DuPont wire twisted pair cable (network cable) RJ45 connector module.

When using arduino temperature measurement humidity, soil moisture detection, ambient light detection, it is often measured distances between locations and arduino motherboard far (over 2 meters), in view of the general DuPont line signal attenuation serious, usually more than one meter of cable length should not use DuPont wire recommended to use shielded cable strong transmission.

So you can use two RJ45 interface adapter module and a 5 m or 30 m of cable, long-distance connection sensor modules or other modules.

Note: This module is generally used in pairs.

Features

  • Standard RJ45 Connector
  • Applitations Wide
  • easy to use
DuPont Line Interface: A total of four pins (GND, VCC, D1, D2), GND to ground, VCC is the power supply, the remaining two of the signal input / output pin. DuPont wire can be connected directly via electronic building blocks module 4-wire or 3-wire.
 
RJ45 Interface : You can take the cable shield and strong, long-distance signal transmission and control.
 
Positioning holes: 4 M2 screws positioning hole diameter is 2.2mm, the positioning of the module is easy to install, to achieve inter-module combination

Cableworks

Τεχνικές Προδιαγραφές

Brand:
OEM
MPN:
OEM
SFP28 (25G):

Cableworks

Ρωτήστε μας

Cableworks

Αξιολογήσεις

Δε βρέθηκαν αξιολογήσεις

  • QoS
  • Νομοθεσία

Cableworks

BEST SELLERS